![]() ![]() Please re-enter password for confirmation: Īdmin password changed. Please change the temporary password as soon as you log on to your This program is used to set a temporary admin password when you have At the # prompt type the command: /etc/overpw It will ask you to Enter full pathname of shell or RETURN for /bin/sh: Just press ENTER Type the command: boot -s in order to boot into single user mode Type any character to enter command mode. Enter boot manager by pressing any key when you see the prompt below: Then, save this new password to the configuration file so that you can log into Network Voyager: (Note that the “” is necessary to specify (NULL) as the old password.) Even if you set a password in step 4, use the dbpasswd command to set a new password:nokia# dbpasswd admin newpassword “”.If a password is required, you will be asked for one. Earlier versions will set a null password. IPSO 3.4 and above will ask you to set a password.It will ask if you want continue, type “y”. After it boots, it will ask you “Enter pathname of shell or RETURN for sh:”, press Enter key.On all other platforms, enter the bootmanager and type boot -s. ![]() On the IP440, this is done by typing -s at the boot:prompt. Boot the system into single user mode.You must have local serial console access to the unit to perform this procedure. Hybrid Installation verification information These apply to IP390, IP560 and IP12XX.ĭisk-based installation verification informationįilesystem 1K-blocks Used Avail Capacity Mounted on Please use the “ df -k” CLI command to verify your configuration as shown in the examples below. for Flash– only systems the / var and / opt partitions are mounted on v9fs ( on-board memory file system).for Hybrid systems (local Check Point logging on HDD) the / opt partition is mounted on v9fs and the / var partition is mounted on the optional hard disk (wd1) ( this assumes the customer has previously enabled the optional HDD for local logging - see article 1350934).for Disk– based systems both the / var and / opt partitions are mounted on the hard disk (wd0).There are two partitions / var and / opt are mounted differently based on the initial system configuration: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |